Product ID:WALLHIDE INTERIOR S/G WHITE & PASTEL, 27-110
MSDS Date:07/30/1992
FSC:8010
NIIN:00N042339
MSDS Number: BSTFZ

PPG INDUSTRIES INC

4325 ROSANNA DR
ALLISON PARK, PA 15101
US

Emergency Phone: 304-843-1300;800-441-9695

Info Phone: 216-572-6111;412-492-5555

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

CONTACT A POISON CONTROL CENTER, EMERGENCY ROOM

RTECS: 9999999ZZ

AVOID FREE FALL OF LIQUIDS IN EXCESS OF A FEW

RTECS: 9999999ZZ

THE LOWEST SUGGESTED EXPOS LIMITS, THE LEL IN FIRE &

RTECS: 9999999ZZ

DECOMPOSITION PRODUCTS DURING WELDING OR FLAME

RTECS: 9999999ZZ

& VISUAL DISTURBANCES MAY INDICATE

RTECS: 9999999ZZ

REDNESS, AND SWELLING ARE CONDITIONS ASSOCIATED WITH

RTECS: 9999999ZZ

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 20-25%

OSHA PEL 10 MG/M3 TDUST

ACGIH TLV: 15 MG/M3 TDUST

CALCIUM CARBONATE; (MARBLE) (LIMESTONE)

CAS: 1317-65-3

RTECS: EV9580000

Fraction By Weight: 10-15%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

HYDROTREATED HEAVY NAPTHA (PETROLEUM)

CAS: 64742-48-9

Fraction By Weight: 30-35%

FILM FORMERS, RESINS, AND ADDITIVES

Fraction By Weight: 25-30%

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST:HARMFUL/FATAL IF SWALLOWED.
EYE: CAUSES EYE IRRIT. SKIN:MAY CAUSE MOD SKIN IRRIT. INHAL:VAP &
SPRAY MIST MAY BE HARMFUL IF INHALED. CHRONIC:AVOID LONG TERM &
RPTD CNTCT. THIS PROD CONTAINS TITA NIUM DIOXIDE. ANIMALS INHAL
MASSIVE QTYS OF TITANIUM DIOXIDE DUST IN LONG-TERM STUDY DEVELOPED
LUNG (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:TUMORS.STUDIES W/HUMANS INVOLVED IN
MFR OF THIS PIGMENT INDICATE NO INCR RISK OF CANCER FROM EXPOS.
POTENTIAL FOR INHALATION OF TITANIUM DIOXIDE DUSTS FROM COATINGS IS
VERY LIMITED. SINCE OVE REXPOSURES ARE NOT EXPECTED, THERE IS NO
SIGNIFICANT HAZARD FOR MAN. REDNESS ITCHING, BURNING SENSATION (ING
9)

First Aid:INGEST:DO NOT INDUCE VOM.EYE:FLUSH EYES IMMED W/PLENTY OF
WATER FOR AT LEAST 15 MIN. SKIN:FLUSH IMMED W/PLENTY OF WATER,
FOLLOWED BY WATERLESS HAND CLEANER & SOAP & WATER IF THE MATL
APPEARS TO ADHERE TO SKIN. INHAL:REMOVE TO FRESH AIR. APPLY ARTF
RESP & OTHER SUPPORTIVE MEASURES AS REQ. OTHER:IF INGEST, ANY TYPE
OF OVEREXP/ SYMPS OF OVEREXP OCCUR DURING/FOLLOWING THE USE OF THIS
PROD (ING 5)

Flash Point Method:PMCC
Flash Point:120F,49C
Lower Limits:0.7
Extinguishing Media:USE NFPA CLASS B EXTING (CARBON DIOXIDE, DRY CHEM,
OR UNIVERSAL AQUEOUS FILM FORMING FOAM) DESIGNED TO EXTING(SUPP
DATA)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT
EQUIP.WATER SPRAY MAY BE INEFFECTIVE.WATER SPRAY MAY BE USED TO
COOL CLSD CNTNRS TO PRVNT PRESS BUILD- (SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD.ISOLATE FROM
HEAT, ELEC EQUIP, SPARKS, & OPEN FLAMES.CLSD CNTNRS MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT.DO NOT APPLY ON (SUPP DATA)

Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERS EQUIPPED W/
PROPER RESP & SKIN AND EYE PROTECTION SHOULD BE PERMITTED IN THE
AREA. REMOVE ALL SOURCES OF IGNITION. TAKE UP SPILLED MATL
W/SAWDUST, VERMICULITE, OR OTHER ABSORBENT MATERIAL AND PLACE INTO
CNTNR FOR DISP.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120 DEGREES F.
STORE LARGE QTYS IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF
NFPA CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:IF THIS MATL IS PART OF MULTIPLE COMPONENT COATING
SYS, READ MATL SAFETY DATA SHEET(S) FOR OTHER COMPONENT OR
COMPONENTS BEFORE BLENDING AS RESULTING MIXTURE MAY HAVE HAZ OF ALL
OF ITS PARTS. CNTNRS S HOULD BE GROUNDED WHEN POURING (ING 6)

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A
NIOSH/MSHA APPROVED SUITABLE RESPIRATOR.
Ventilation:PROVIDE GEN DILUTION/LOCAL EXHAUST VENT IN VOL & PATTERN TO
KEEP CONC OF INGRED LISTED IN ING SECTION BELOW (ING 7)
Protective Gloves:NITRILE RUBBER/NEOPRENE RUBBER GLOVES
Eye Protection:ANSI APPROVED CHEMICAL (OTHR PROT EQUIP)
Other Protective Equipment:IMPERMEABLE APRON. EYE PROTECTION: WORKER
GOGGLES AND FULL LENGTH FACESHIELD .
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXTING MEDIA:NFPA CLASS II COMBUST LIQ FIRES. FIRE FIGHT PROC:-UP &
POSS AUTOIGNIT/EXPLO WHEN EXPOSED TO EXTREME HEAT. IF WATER IS
USED, FOG NOZZ ARE PREF. EXPLO HAZ:HOT SURF. TOX GASES MAY FORM
WHEN PROD IS CONTACTED BY FLAME OR HOT SURF.HAZ DECOMP:FUMES
INCL:CARBON MONOXIDE.

HCC:F4
Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:0.7
Vapor Density:HVR/AIR
Spec Gravity:1.23 (H2O=1)
Evaporation Rate & Reference:12 (BUTYL ACETATE=100)
Solubility in Water:0.1%
Appearance and Odor:VISCOUS LIQ W/AN ODOR CHARACTERISTIC OF THE
SOLVENTS LISTED IN ING SECTION.
Percent Volatiles by Volume:54.30

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAZ DECOMP PROD WHEN
HEATED. WELDING, BRAZING/FLAME-CUTTING ON SURF COATED W/THIS PROD
MAY PRDCE (SUPP DATA)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL, AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WA STE MANAGMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.